JANICKI INDUSTRIES INC -
NADCAP Approved
90078410
Independent Processor
34240 STATE RTE 20
HAMILTON , WA 98255 United States
Phone: 360-814-1708
Fax:
90078410
Independent Processor
34240 STATE RTE 20
HAMILTON , WA 98255 United States
Phone: 360-814-1708
Fax:
Selected sector: AS
Specification
ProcessDescription
Category
Structural Adhesive Bonding with Epoxy Film Adhesive
Composites
Limits:
None
Structural Adhesive Bonding with Epoxy Paste Adhesive
Composites
Limits:
None
Process Specification for Sealing, Integral Fuel Tank and Fuel Cell Cavity
Finishes/Coatings
Limits:
Not Approved for Appendix “A”
Limited to pre-measured sealant dispensing cartridges (Semkits)
Surface Preparation for Structural Adhesive Bonding
Chemical Processing
Limits:
Limited to Type I only
Surface Preparation for Structural Adhesive Bonding, Composites
Composites
Limits:
None
Fabrication of Wire Harnesses
Miscellaneous
Limits:
Limited to MRB repairs only
Curing Procedures for Composite Laminates and Sandwich Assemblies
Composites
Limits:
Process Specification for Wet Layup of Composite Laminates and Foam Sandwich Structures
Composites
Limits:
Limited to Type IV ONLY
Not Approved for Appendix “A”
PROCESS SPECIFICATION FOR WET LAYUP OF CARBON FABRIC FIBERGLASS FABRIC OR COPPER MESH ON CURED COMPOSITE SURFACES
Composites
Limits:
Excludes Appendix A
Process Specification Fabrication of Out-of-Autoclave, 350°F Cure, Epoxy Laminates
Composites
Limits:
Not Approved for Appendix “A”.
Process Specification for Fabrication of Pi Joint Composite Structures Utilizing 350°F Curing Out-of-Autoclave Materials
Composites
Limits:
Process Specification For Fabrication Of Current Carrying PI Joint Structures For Lightning Arc Mitigation
Composites
Limits:
None
Machining of Nonmetallic Honeycomb Details
Composites
Limits:
Not Approved for Appendix A
Process Specification for Fabrication Of 350°F Curing Out-Of-Autoclave Epoxy Composite Structure, Bonded, Cocured, Or Cobonded
Composites
Limits:
Installing Inserts, Hardpoints, and Edge Filler in Composite Sandwich Structure
Composites
Limits:
Limited to
Type I, II & V only
Hole Preparation, Drilling, Mach.,Trimming for Composite/Metallic Structure
Composites
Limits:
Not Approved for Appendix A, B & C
Process Specification for Contamination Free Hole Preparation, Drilling, Machining and Trimming of Composites and Composite/Metallic Structures
Composites
Limits:
None
Ultrasonic Inspection of Composites and Bonded Assemblies
Non-Destructive Testing
Limits:
Limits; Not approved for Appendix A & B
Non-Destructive Inspection of Composite Structures
Non-Destructive Testing
Limits:
Area Requirements for Composite Fabrication
Composites
Limits:
Not approved for Appendix A & B
Process Specification for Area Requirements for Adhesive Bonding and Composite Fabrication of PI, Green Tie and Splice Joint Primary Structures (Controlled Bonding Area)
Composites
Limits: